Phiten Titanium Tornado Necklace

You can make your own Tornado Necklace from any of our Titanium Necklaces or Camouflage Titanium Necklaces.

Here's how:


Please read through the instructions before starting 1. Secure the 2 necklaces with a rubber band, as seen on the photo. The male and female part of the clasp should be placed on the same ends (as shown on photo)
2. Start winding 1 of the necklaces		3. Wind the other necklace in the same direction
4. Twist the necklaces in the opposite direction of the wind (if you wind the necklace to the right or clockwise, then twist the necklaces to the left or counter clockwise).		5. When finished twisting, remove the clasp and rubber slide piece on one of the necklaces.
6. On the other necklace, cut out a little portion of the rubber slide piece, enabling the other necklace end to fit.		7. After the cut

8. Slide the other necklace into the where the cut was made and use super glue to hold it in place		9. Completed 26"�¨roughly 20" 22"�¨roughly 18"
If you use 2 x 26" necklace, it's going to be about 19.5 inch If you use 2 x 22" necklace, it's going to be about 17.5 inch

You may also be interested in these options:

Make Your Own Triple-Braid Necklace - Create your own super powerful Triple-Braid necklace from three of our Titanium or Camouflage necklaces.

Make Your Own Misanga Braid Necklace - Create your own "Misanga" braid necklace from one of our Titanium or Camouflage necklaces.